[Simh] vax750 and simulated hard-wired serial connections and Raspbian

[Mark Pizzolato]

On Tuesday, May 9, 2017 at 10:15 AM, Alan Perry wrote:
> I am participating in the UUCP project and have set up a SIMH vax750 on a
> Raspberry Pi. I am using the 4.3BSD bits that the UUCP project lead
> (Warren) provides to install the system and followed his instructions for
> configuring it.
> 
> It uses a simulated hard-wired serial connection to communicate with a
> remote simulated host over TCP/IP. However, I have not been able to make
> this connection work. Everything seems good on the simulated VAX. But when
> I initiate connections to the remote host, I see no corresponding activity on
> my network.
> 
> Any suggestions of specific things to check to figure out why nothing is going
> out to the network?

To start understanding what is going on, please provide:
1) the output of SHOW VERSION executed at the sim> prompt of your simulator.
2) the same for the remote simulator.
3) The configuration that is being used on BOTH simulators

- Mark