[Simh] PDP-15/76
Pontus Pihlgren
pontus at Update.UU.SE
Wed Mar 16 04:06:37 EDT 2016
On Tue, Mar 15, 2016 at 06:31:35PM +0100, Mattis Lind wrote:
>
> The documentation was the only thing that remained from the PDP-15
> installation at Standard Radio & Telefon (part of the ITT company) that was
> used for development of the ATC (Automatic Train Control) system.
An I have DECtapes from this system. I recall at least one being labled
DOS. Could the content of these tapes be of help?
In that case I should make another effort to dump these tapes (I have
dumped a few).
/P
>
> /Mattis
>
> 2016-03-15 17:46 GMT+01:00 Bob Supnik <bob at supnik.org>:
>
> > I've pulled together the hardware pieces for the PDP-15/76 (PDP-15 with
> > UC15 PDP-11 IO processor), so now it's time to consider what software can
> > be run.
> >
> > The most likely candidate is XVM/DOS-15. While vanilla DOS-15 had UC15
> > support at some point, neither a complete source kit nor the appropriate
> > restore DECtape images seem to be available. The XVM/DOS-15 kit has all
> > required DECtapes, but it lacks the paper-tape elements. Fortunately, these
> > exist in source form in the XVM/DOS-15 source kit.
> >
> > ABSL11 - a PDP-15 read-in mode tape that allows PDP-11 absolute binary
> > tapes to be read into shared memory and moved to private memory. (This is
> > not strictly necessary, because the PDP-11 side has its "hardware" binary
> > loader via the LOAD command.) This is used to load PIREX. It must be
> > assembled on the PDP-15.
> >
> > PIREX - a PDP-11 absolute mode tape that runs the PDP-11 IO executive. It
> > has to be assembled on an -11, so the source must be loaded into an RT11
> > system, assembled, and punched out as a binary paper tape image. It's
> > possible that the macro11 cross assembler could be used instead.
> >
> > DOSSAV - a PDP-15 binary tape that restores a distribution kit (usually
> > two DECtapes) to RF, RP, or RK disk. It must be assembled on the PDP-15. It
> > uses PIREX.
> >
> > RKBOOT - a PDP-15 read-in mode tape that uses PIREX to boot a PDP-15
> > operating system off the RK15 (an 18b RK11). It must be assembled on the
> > PDP-15. It uses PIREX.
> >
> > /Bob
> > _______________________________________________
> > Simh mailing list
> > Simh at trailing-edge.com
> > http://mailman.trailing-edge.com/mailman/listinfo/simh
> _______________________________________________
> Simh mailing list
> Simh at trailing-edge.com
> http://mailman.trailing-edge.com/mailman/listinfo/simh
More information about the Simh
mailing list