[Simh] New NIC not recognized
Jean-Yves Bernier
bernier at pescadoo.net
Sat May 24 21:43:14 EDT 2014
I have simh running on CentOS inside VirtualBox.
sim> show xq eth
ETH devices:
0 eth0 (No description available)
I add a network adapter in VirtualBox,
then create /etc/sysconfig/network-scripts/eth1
$ sudo ifup eth1
Determining if ip address 192.168.0.201 is already in use for device eth1...
$ ifconfig
eth0 Link encap:Ethernet HWaddr 08:00:27:DA:68:3D
inet addr:192.168.0.101 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::a00:27ff:feda:683d/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:57 errors:0 dropped:0 overruns:0 frame:0
TX packets:50 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:7554 (7.3 KiB) TX bytes:6543 (6.3 KiB)
eth1 Link encap:Ethernet HWaddr 08:00:27:A9:51:87
inet addr:192.168.0.201 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::a00:27ff:fea9:5187/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:12 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:816 (816.0 b)
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Everything fine. Now...
sim> show xq eth
ETH devices:
0 eth0 (No description available)
Why simh don't see my new interface?
Any help appreciated.
--
Jean-Yves Bernier
More information about the Simh
mailing list