[Simh] Initializing disks under RT11 (Ken Hall)
Bob Supnik
bob at supnik.org
Wed Dec 21 14:27:36 EST 2011
Ok... I have it. The stock systems have only two RL units (see the
RT5.0 Installation Guide). So when you try to init units 2 or 3, the
requests go to unit 0 and fail. (RT11 could give better error messages,
but it doesn't.) This code snippet from the distributed sources
confirms it:
.IIF NDF DL$UN, DL$UN == 2
.IIF GT DL$UN-4, DL$UN == 4
.IIF LE DL$UN, DL$UN == 1
.IRP X,<\DL$UN>
.SBTTL *** THIS HANDLER SUPPORTS X UNITS ***
.ENDR
You need to generate a custom system to get 4 units.
/Bob
On 12/21/2011 1:10 PM, Ken Hall wrote:
> I'm just letting the emulator create the file. I have three defined in the
> cmd file, DL0-DL2. Disks that are already initialized (DL0 and DL1) are
> fine, but if I delete DL2 and let the emulator recreate it, I get these
> errors. So far the only way I've been able to create a working disk image
> is to copy an existing one, and remove all the files.
>
> Bob, is there anything special in your startup cmd file for the disks? This
> is what I have:
>
> [ken at raptor Disks]$ cat rt11.cmd
> ATTACH RL0 rt11run.dsk
> ATTACH RL1 rtv53_rl.dsk
> ATTACH RL2 rt11dat.dsk
> SET RL2 BADBLOCK
> BOOT RL0
>
> RL2 is the one I'm trying to initialize.
>
>
> -----Original Message-----
> From: simh-bounces at trailing-edge.com [mailto:simh-bounces at trailing-edge.com]
> On Behalf Of Bob Supnik
> Sent: Wednesday, December 21, 2011 12:51
> To: simh at trailing-edge.com
> Subject: Re: [Simh] Initializing disks under RT11 (Ken Hall)
>
> I just tried this under both RT v4 and v5.3, and it works fine on a stock
> release.
>
> However, if you either (a) fail to write the bad block table or (b) attach
> an RL01-sized file to a drive that's declared to be an RL02, rather than
> AUTOSIZE, RT will get very confused, and the INIT will fail.
>
> /Bob
>
> On 12/21/2011 12:00 PM, simh-request at trailing-edge.com wrote:
>> Initializing disks under RT11 (Ken Hall)
> _______________________________________________
> Simh mailing list
> Simh at trailing-edge.com
> http://mailman.trailing-edge.com/mailman/listinfo/simh
>
>
More information about the Simh
mailing list