<div dir="ltr"><div>Hi, forum.<br>
<br>
After a few years out, I decided to put simh-vax up again.<br>
Since my old files were lost on an old desktop, now I am setting simh-vax on a laptop with eth0 <br>
and wlan0, as network interfaces.<br>
My first goal was just to put vax-vms running again. That's ok. VAX-VMS073 with ethernet support<br>
installed.<br>
Now, trying to get telnet working, after insert licenses and install tcpip, I stuck with <br>
simh networking again. <br>
Following docs on simh-3.9 (readme_ethernet-howto), I did:<br>
<br>
-my LAN 192.168.25.0 - wlan0 192.168.25.23 - eth0 not in use.<br>
-linux side: <br>
-after setting up a tuntap tap0 is available.<br>
-bridging: br0 ip address <a href="http://192.168.25.100/24">192.168.25.100/24</a> with eth0(ip 0.0.0.0) and tap0(ip 0.0.0.0)<br></div>-at this point doesnt matter simh connections outside my lan.<br><div>
<br>
-(simh)vax-vms side:<br>
-xqa0 attached to eth0 (QE0 ip 192.168.25.200) and <br>-xqb0 attached 
to tap:tap0 (QE1 ip 192.168.25.220). <br>No success.<br><br></div><div>-trying with xqa0 disabled on vms side:no success<br></div><div></div><div>
<br>
I've checked and tryied to set QE0 to ip 0.0.0.0, with no success (invalid address under vms).<br>
So I cant figure out how to put vms talking to host via tcpip. Even after several trying on <br>
bridging.<br></div><div>Build vax with no problem; bootting and installing VMS073 with no problem too.<br></div><div><br></div><div>Using simh-3.9.0 (although show version reports me simh-4.0 beta)<br></div><div>OS linux slackware64  14.1(with multilib)<br></div><div><br>
Any help welcome.<br>
thanks.<br>
<br>
marx<br>
<br clear="all"><br>-- <br><div class="gmail_signature">T+<br>[]´s<br>marx   :-p</div>
</div></div>