[Simh] KA/KI READIN mode (was: Looking for a RIM10B paper-tape image)
rich
rich at sky-visions.com
Mon Jan 23 08:19:00 EST 2017
Hi,
> Timothe Litt wrote:
> > Readin mode for the PTR (KA10/KI10) sets the reader to (hardware)
> > binary mode, reads one IOWD, does a BLKI until exahusted, and XCTs
> > the last word loaded.
>
> Was it possible to use readin mode with disk controllers?
On the KA/KI you could read in from the RC10 and RH10 controllers.
The RP10 did not support read in. Also the PTR and TMA/TMB
controllers supported read in.
> The reason I ask is that ITS DSKDMP seems to include code for a disk
> boot block, but it's a bit of mystery how it was used, if at all. ITS
> people say the KA machines were cold started using paper tape.
The KL and KS had a front end which did the work of getting BOOTS
loaded into memory.
For my KA/KI simulator I have added support for read-in off the RP10
controllers, by simulating a read of blocks 4-7 and dropping them
into memory where they should be.
Rich
--
==========================================================================
Richard Cornwell
rich at sky-visions.com
http://sky-visions.com
LinkedIn: https://www.linkedin.com/in/richard-cornwell-991076107
==========================================================================
More information about the Simh
mailing list