[Simh] how to enable tc11 (was Re: RT-11 source)
Ron Young
rly1 at embarqmail.com
Mon Oct 24 17:48:47 EDT 2016
Your message dated: Mon, 24 Oct 2016 17:39:23 -0400
--------
> > On 24 October 2016 at 17:30, Ron Young <rly1 at embarqmail.com> wrote:
> > ok, so try a unibus system 11/34 (same simh session)... I would hope that
> > TC would get configured instead of disabled... I have googled for
> > documentation, and found some docs current pdp11_doc.pdf, and simh_vmio.pdf
> > (not sure of version) but I got lost...
> >
> The TC11 is like the DH[|U|V|Q]11 simulation (device VH). It needs to
> be specifically enabled:
> SET TC ENABLED
> That should enable your TC11 device.
>
That did it... (I was trying SET TC0 ENABLED)
>
> By the wya, can RT-11 V2 even run on an 11/34? You might want to try
> it on an 11/20 or 11/40.
>
I was just trying to read the dta images using RT11v4... then
I'll try the "smaller" hardware.
thanks all...
-ron
===============================================================================
Ron Young rly1 at embarqmail.com
More information about the Simh
mailing list