[Simh] Burroughs B5500 simulator.
b4 at gewt.net
b4 at gewt.net
Sat Jan 30 13:47:41 EST 2016
I would be interested in all your simulators. ;)
----- Original Message -----
From: "Richard Cornwell" <skyvis at sky-visions.com>
To: simh at trailing-edge.com
Sent: Friday, January 29, 2016 11:55:17 AM
Subject: [Simh] Burroughs B5500 simulator.
Hello All,
I have just finished off a simulator for the Burroughs B5500 system. It
currently supports 1 or 2 CPU's, up to 20 disk units, or 10 with DFX
support, Drums, 1 or 2 Card readers, 1 Punch, 1 or 2 Line printers, and
up to 8 terminal lines (more can be added). The simulator runs either
MCP XIII or MCP XV (including CANDE). I have not tested it with the
latest version of the simH from the Git hub. However it should work
just fine.
I will give it a test with the latest version over the next couple of
weeks. The simulator also includes the start of a generic Card
reader/punch modules. Feedback on this would be helpful, perhaps it can
be integrated into the main distribution. Once I finish off support
for handling EBCDIC cards.
While I am fixing bugs that are reported I will see if I can finish off
my KA10/KI10 simulator. If anyone is interested in helping me write a
Dectape controller for the 10, please contact me.
If there is interest I can put the simulator on the github to make it
part of the main distribution.
Rich
--
==========================================================================
Richard Cornwell
skyvis at sky-visions.com
http://sky-visions.com
LinkedIn: https://www.linkedin.com/in/richard-cornwell-991076107
==========================================================================
_______________________________________________
Simh mailing list
Simh at trailing-edge.com
http://mailman.trailing-edge.com/mailman/listinfo/simh
More information about the Simh
mailing list