[Simh] Segmentation fault when running the MIcrovax emulator

[brian]

I put a "show version" in vax.ini.

This is the output from trying to run the program


VAX simulator V3.8-1
NVR: buffering file in memory
VAX simulator V3.8-1 [64b data, 64b addresses, Ethernet support]
RQ: unit is read only
Segmentation fault


Brian.

On 01/07/2012 01:31 PM, Sergey Oboguev wrote:
> Build options can be checked with "show version" command.
> It should display something like
>
> sim> sh vers
> VAX_MP simulator V3.8-1 [64b data, 64b addresses, Ethernet support]
>
> ----------------------------------------------------------------------
> *From:* "Boucher, François" <boucher.francois at uqam.ca>
> *To:* simh at trailing-edge.com
> *Sent:* Sat, January 7, 2012 10:21:33 AM
> *Subject:* Re: [Simh] Segmentation fault when running the MIcrovax
> emulator
>
> Maybe your microvax emulator was not compiled with the ethernet (XQ)
> support?
> Just to test this, please remove the two lines:
> set xq mac=00-1C-25-EA-22-09
> attach xq eth0
>
> that are related to the ethernet interface, then run the microvax again.
> Hope that helps,
>
> François
>
>
> _______________________________________________
> Simh mailing list
> Simh at trailing-edge.com
> http://mailman.trailing-edge.com/mailman/listinfo/simh